Comparison of properties between textured transfer coating and textured suspension squeegee
	Textured transfer coating		Textured suspension rubber coating
Gluing control	Depending on the size of the dot, the amount of glue in a single dot can not be adjusted.		Depending on the depth of the dot size, the glue content of a single dot can be adjusted online by ± 5g.
Peel strength	good		Very good. It is usually only necessary to transfer 70-80% of the amount of glue applied to achieve the same peel strength
Maximum linear speed	100m/min--130m/min		150m/min--300m/min
Maximum linear speed	Soft feel, good breathability		The distribution of rubber wire is more flat and even, and the handle is softer. Due to less glue demand for the same peel strength, the air permeability can reach 80-100% compared with transfer coating
Weight range of gluing gram	The glue amount of a single dot can not be adjusted.		The glue amount of single dot can be adjusted online ± 5g.
Coating accuracy	Uncontrollable, due to the precision and mechanical stability of the embossing cots, as well as the thermal expansion of the cots, the phenomenon of glue penetration and degumming is easy to occur		± 5% without embossing cots, free from any influence of mechanical stability, no bad phenomena such as glue penetration/degumming, and the composite products are stable
Post maintenance	Frequently changing the width of the rubber deflector will lead to a short life of the rubber deflector. The rubber deflector needs to be replaced frequently, and the scraper blade needs to be replaced in about 30 days. The rubber roller needs to be repaired and replaced frequently, which is troublesome to disassemble.		Due to the change of the gluing width, it is unnecessary to adjust the rubber baffle, which has a long service life. Compared with the scraper pressure during transfer coating, the pressure of suspension scraper coating is 2-3KG, so the life of the scraper is relatively long.
	The glue width is often changed, and the rubber baffle is easy to be damaged	Cots are easy to deform and need maintenance, and the precision should be well controlled.
Applicable glue	PSA, structural glue PUR glue, EVA glue and other conventional glue		PSA, structural glue PUR glue, EVA glue and other conventional glue
Gluing substrate	Not suitable for high breathable and perforated materials, and not suitable for low gram weight materials, such as (8-15g non-woven fabrics, etc.)		Breathable and non breathable materials, high and low weight materials, mesh materials can also be coated with glue
Maximum width of glue coating	400mm-1800mm		400mm-3400mm
width	Non standard design, the current case width is 1300-1800, The effective width of glue coating can be adjusted through the rubber baffle and the width of rubber roller can be changed at will		At present, the maximum width is 3400, without any adjustment.


Temperature effect	It is greatly affected by the ambient temperature, or the air heating temperature is increased		It is greatly affected by the ambient temperature, or the air heating temperature is increased

NEWS

Comparison of properties between textured transfer coating and textured suspension squeegee